Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am looking for opinions of the best way to deal with WOL. After converting all of the links from core to closet from l2 to l3 WOL broke. To get it working I either have to back out and convert my links back to l2 or turn on ip-directed broadc...
I walk around with a laptop but can't find it. It appears to be a "b" connection. It gives me a strong signal in the ground floor and all over the data center but nothing on the first floor. It appears to be on all of the time.
Considering redundancy, getting as much bandwidth as possible and future QoS support, what is the best way to bond two T1's? I am currently running multilink because in the lab it behaved the way I wanted. I have two identical sites, one works fine...
I have one 6500 switch with a sup720 which sucessfully gets time from the Internet. Most of my routers and switches were pointing to 10.210.210.1 as an NTP source. When cutting over to a new circuit the 10.210.210.1 address went away. When I tried...
I have three 6509 switches, two core devices with sup720's and one closet switch with a supII. I am using VLC media player as my test multicast sender / receiver. I am running pim sparse-dense mode with auto RP. My switch named EVEN is the RP (and...
Thanks for the reply, unfortunately the servers are in different buildings and with my configuration there are no VLANs. Each switch is routed to the core and there is no 802.1q.
10.1.1.254 is a stratum 3 device and is a 6500 with a sup720 running native mode. It is getting time from the Internet.I am not sure if this is relevent but the only devices which can get time from it are three switches connected over dot1q pagp tru...
