No documentation about using EIGRP with what kind router can build a large network using Metro Ethernet. Cisco7600 become unstable unstable after applying over 600 eigrp neighbors.
EIGRP seems no limitation. No documentation about using EIGRP with what kind router can build a large network using Metro Ethernet. Cisco7600 will turn unstable after applying over 600 eigrp neighbors.
Right, CPU 100% only happens when one interface coming up. I am interesting how your 800 remotes connecting to main site? Using subinterface gi0/0.x for each remote?
Hi, I should explain more.Your 1st Question:The problems is I can only get NAT to work if I put a static route pointing to VLAN 60.Answer:int vlan60 define ip range from 100.4.20.0 to 63So, you should add static route before routing process can know ...
>ip address 100.4.20.2 255.255.255.192IP range is from 100.4.20.0 - 63*** ip route 100.4.20.64 255.255.255.192 Vlan6010.4.20.64 - 127 is out of the IP range
Offical (not forum):This chapter describes how to use Hot Standby Router Protocol (HSRP) to provide routing redundancy for routing IP traffic without being dependent on the availability of any single router. To use this feature, you must have the enh...