Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I have configured DHCP snooping on cisco switch and configured two DHCP scope on R1 and R2 to test the DHCP snooping functionality. Config output from the switch #ip dhcp snooping #ip dhcp snooping vlan 1#interface range fast 0/2-3#ip dhcp...
Hi engineers, Trying to build site to site vpn from Z4 Meraki to forti firewall but meraki dashboard pop below messages, What would be the reason and the solution ? The VLAN subnet 172.21.16.8/29 overlaps with a remote VPN subnet on the non-meraki pe...
Hello guysCould any engineer help me to cover wireless topic as CCNP level.1- what is service port in WLC it's usage ? why we assign ip for it ?2- which port is used to update/convert AP to LWAP ?3- during initializing WLC it requires default router ...
Hello guysI read cisco documentary about CSMA/CD it is a mechanism used with hub to detect collision while multiple access but I couldn't find anything about its timer and jam message also is it still mechanism for switch while each port of switch is...
I intentionally put both dhcp ports into trust status if any of them work but none work since dhcp snooping enabled on switch. There is nothing wrong with the dhcp servers. i tested them before dhcp snooping !!!
Yes, when we connect to interfaces between two switches, assume (SW1 and SW2) point to point.Example : SW1 with lowest Bridge ID become Root Bridge, and SW2 become Non-root, after port cost, port priority are the same, then port number break the tie ...
Please see this diagram below : All I understood, just asking why changing port-priority F0/2 on SW2 does not change the path from Block to Forwarding state and does not block the F0/3 toward SW3 ?I see changes only when i change port cost.why port p...
