Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have 2 questions regarding CBTS [MPLS Traffic Engineering (TE)--Class-Based Tunnel Selection]:- There is a statement in the documentation "The operation of CBTS is not supported with Any Transport over MPLS (AToM), MPLS TE Automesh, or label...
Hi All,we are registering a lot of output drops on ATM E3 interface, the same number of drops is identified as packets late drop. There are no any drops on any subinterface on atm vc level. As you can see the volume of output traffic is low. It is AT...
Hi All, I am looking for the explanation of increasing Registration request error - No resources (code 130) on HA. In rfc3220 I find only 130 - insufficient resources. No any other explanation on cisco CCO or web.Thank jm.,
Hello,We have c7600 running IOS 12.2.33 SRA3. I am looking for the way how to identify MDI/MDIX status of the 10/100/1000BaseT GigabiEthernet port. I am able to use "show interfaces gigabitEthernet 3/1 controller" command in this IOS release, but the...
Harold,Thank You for Your answer, officially ATOM is not supported by MPLS TE CBTS (this is the statement from TAC).Anyway, we have done some tests, there were some problems on application level with FTP & NFS.Regardsjm.,
OK, auto-MDIX feature is working without any problem, but the question is: "How is it possible to identify the state of the Auto-MDI/MDIX feature for 10/100/1000 Mbps ethernet port, is there a Cross-over cable used between devices or Straight-Through...
