In BGP configuration I want to advertise routes with one AS to FW. That's how it looks now. *> 10.0.0.0/24 10.10.1.1 0 0 0 65001 65101 65111 65150? What I want to achieve. *> 10.0.0.0/24 10.10.1.1 0 0 0 65001 Do someone know how to do it?

Hi, I would like to start by describing our topology: we have a leaf-spine architecture with BGP configured between the two spine switches and the leaf switches. The leaf switches are in VLT, while the spine switches are not. My question is: if we ha...

Hi,We have a problem with the same Mac address on VLANs that go through a few switches.Another problem is that when we ping gateay local address ping works but when we started pinging to other ip that do not exists the ping to local gateway stops wor...

Hi, we have bgp running on the switch and I would like to make it so that a specific network, for example 10.10.10.0/24, is broadcast to a different bgp neighbor than all the others. I tried to prefix it with the list assigned to the route map but it...

Hello, We replace the Spoke router with a new one and the HQ remains older and our tunnel status is "MM_NO_STATE".  Does someone knows is the crypto isakmp group should be the same on HQ and Spoke. On new router i can set value of 24, on old router t...