Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am in the process of updating a Mobility Express WLC from Cisco. I have deployed the TFTP server and the correct images and the pre-download worked on all access points except one. In the following picture you can see what output I get.
I l...
Hello,I am in the process of implementing an ISE Guest solution. I have 2 nodes for redundancy reasons. I send the approval and the credentials for the guests via mail. I have 2 questions about this. If I shut down my primary node so that the backup ...
Hello,
I am in the process of implementing an ISE Guest Solution. Sponsors need to approve the request from a guest. It hasbeen configured that the login to the sponsor portal should be done via SAML. Unfortunately, I then have the problem that the ...
Hello,
I have an ISE deployment consisting of 2 nodes. However, for the policy set I need to know which ISE processed the request. If I look in the Radius log, there is a Policy Server item and then the host name of the ISE. How can I check in my Aut...
Hello,
unfortunately I did not get smart from google. With the following command configure AAA so that I can log in from a Radius server. I understand that and if I add enable at the end, then the enable password is virtually fallback. Now our config...
Thank you very much.
The problem is not with the WLC itself. When upgrading, I get the same result with the access point where the Mobility Express is running above, namely that there is not enough memory available.
I want to upgrade from version 8.10.151.0 to version 8.10.190.0. I have not found anything about this in the release notes.It is the following AP model: AIR-AP2802I-E-K9
There are also several of this model and here the pre-download worked normally. ...
yes, if I promote the second node as primary, it works. Is there no way to do this automatically? It is not possible to install a third node. This is not a redundancy for me if I still have to intervene manually?
