Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a scenario where we have 2 Nos. of Cisco C9606 Switches with Dual Supervisor Engine and 1 No. of Copper Line Card and 1 No. of FO Line Cards. We have installed 3 Nos. of Power Supplies (3000W). The Input Power is 110V AC. With three PSU runni...
Hi
I am working on a scenario, where I have requirement to configure Hotline Phones in a Point to Multipoint Configuration. One Hotline Phone in a central location and three remote hotline phones in three different locations having different extensi...
I am working on a scenario where I have Cisco IE-3300-8U2X Switch with Expansion Module IEM-3300-16P=. We have a third party phone from FHF, due to Industrial Standards this Phone supports only POE Mode B. While Cisco Switch supports POE Mode A.
We a...
Hi ...
I am facing an issue.. I have FHF Industrial Phone that accepts 802.3af (Mode B) and 802.3bt (type 3). I have Cisco IE-3300-8U2X-A with Expansion Module IE-3300-8U2X-A. I have supplied 54VDC as Input to Cisco Switch.
I used the command "power...
It Says%CMRP_PFU-3-PWR_MGMT_ALARM: Chassis 1 R0/0: cmand: WARNING: System does not have sufficient input power for minimum reliable operation requiring 2020 Watts. The System needs 2080 Watts of Additional Power.
Is it Possible that All three remote Hotlines converge to central hotline. The communication needs to be one way only. from remote hotlines to central Hotline.???
Dear Maren,
In our scenario, we do not want to use softkeys. Our requirement is when one phone goes off - hook, other three phones should ring and we do not need any manual intervention.
Regards,
NA
