Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So we have two gateways both reside in the same Core closet. We have two PRIs incoming in from our telephone provider and then our outgoing calls go out internet pipe via the phone provider. We had a couple events where our GW1 went down. Basically s...
I am working on a hub and spoke topology. I have my Areas configured and interfaces as well on the hub and spokes but I believe I must be missing some or doing something wrong. As right right now the spokes see only the hub as a neighbor however the ...
Hello, How do I give a user the capability to forward the main phone number (currently is a Auto Attend). Ideally I want to do a hotkey so in the event of an emergency it quickly forwards to a number that is predefined. Anyone have any thoughts on ...
So we just migrated the last building to webex and its come to my attention that the Call Pickup Groups via Webex are confusing. I say this because the options back in CUCM call pick up groups use to have the ability to show calling party information...
Hello, So I am trying to configure phone gateway we have at a location that is directly attached analog to a old paging system. Which activates on a #25. Right now in WebEx I have the gateway CUBE connected as trunk to WebEX with the DialCast 31110. ...
So basically we have two gateways for redundancy. They are connected to WebEx via vCube to handle external calling incoming and outgoing. The issue with sip-ua not reregistering from a quick network loss has to be maybe a bug with the frimware (did n...
Yeah I noticed it was the Spoke it was set to 1419. Now I just need to find out how to get Remote Access VPN to show in the OSPF routing and Layer3 nets. Will do thank you
Routes are now flowing and I have Full connection to all the neighbors!!Neighbor ID Pri State Dead Time Address Interface10.100.0.5 0 FULL/ - 0:00:33 10.255.255.5 S2S-HubSpoke_va2110.100.0.6 0 FULL/ - 0:00:35 10.255.255.6 S2S-HubSpoke_va2010.100.0.4 ...
No problem I appreciate the help. So from looking at the CLI on the spoke side I spotted the issue my VTI66 (handling the connection to the FTD) had a wrong MTU and the MTU matching was set to on. I adjusted to match the MTU of the FTD and wahlah!!!!...
Meaning they are just in Exchange state. Wording was a bit off yes. What I mean is all the neighbor spokes show up to hub and their router ID but the state is stuck in "EXCHANGE"
