Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
I've been tasked with adding new configuration to a SCA BB SCE8000 with a corresponding subscriber manager. The subscriber manager (in pull mode) identifies the subscribers a combination of the DHCP Lease Query LEG (used to retrieve su...
Hello Everyone,I have a requirement to select a farm based on source IP address. I tried creating a match all class-map that matches on the virtual-address and source address but I get this message.LB01/Admin(config-cmap)# match source-address x.x.x...
is it possible to have Cisco ACE4710 load balance servers that are located in different subnets? it should be ok as long as the ACE has the correct routes to those networks. right? if it can it should also be able to do layer7 policy decisions corr...
Hello Sirisak,Do you still have the guide? I clicked on your link for the blog post and could not find it.I have opened a case with TAC but there is no engineer available.Regards,David Farje
I'm getting the same error message but I'm attempting to switch from sybase to mysql.the tables get created in MySQLmysql> show tables;+-----------------------------+| Tables_in_apricot |+-----------------------------+| CONF_SE_TZ_OFFSET ...
Through my tests with nfdump-NSEL I found it did not work simply because the ASR NELis a different flow template with different type fields./* ASR NEL flow template */templateId=259: id=259, fields=11
field id=8 (ipv4 source address), offset=0, l...