Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts,I have configured sip trunk between freepbx and cucm6 and was successfully done. But problem is that when I try to call cisco ip phone from sip phone and hangup sip phone after 1 or 2 rings, cisco ip phone remains ringing and after sometim...
Dear All,Is it possible to configure callmanger 4 as subscriber and callmanager 6 as publisher in the cluster? If it is then how we can do this?regards,RAHIL
I have build topology like this:host------c2950(f0/3)------(f0/4)c3550(f0/41)----modem-----InternetI wanted to monitor c3560 port where modem is connected from host. So for that I configured rspan. configurate show below. But problem is that after co...
Thnx campbell. I was in confusion at that moment and was trying to integrate both cucm6 and 4 in cluster but logs were showing that cucm 4 which was to be made as subscriber was able to resolve the ip but wasn't able to \\cucm6\c$.regards,RAHIL
Hi,On tcpdump I see gre tunnel created from linux to router which it shows something like "port 47 unreachable".For this I tried a lot but no luck. Can u suggest me any specific release so that I can use to test this again?Regards,RAHIL KHAN
