Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a Cisco 877W w/ IOS 12.4-15.T7 that does not provide dhcp addresses to wireless clients. The Wired ethernet clients can receive addresses but not the wireless. I have the exact same router, config and O.S. with 4 other client's routers but...
OK...so i am puzzled. Here is my story. I have a WAN, where I administer my own LNS to provision DSL for my clients(which I also administer). I have been attempting to configure QOS at the client end (using Cisco 837's and 877's). I have NBAR support...
I hope this is the correct forum for this but here goes. I need to find a bandwidth calculator or conversion tool that also takes into effect overhead. It seems as though there aren't any online calculators that do this properly. I found one here htt...
Hello,I was curious as to how granular I can be with bandwidth management on a C2950 switch. What I would like is to be able to restrict any SESSION to 300 kilobits or less depending on the IP Traffic type. Basically what I have is MS Terminal Server...
We have a C2621 as our LNS connecting to our ISP's LAC. I need to upgrade my underpowered C2621 router and have purchased a C2811 to replace it. I was hoping to simply copy over the config from the 2621 to the 2811 but it seems ISL doesn't work in th...
Actually it turns out the config was fine. The issue was the Passphrase itself. I was generating passwords 63 characters in length with symbols included. Question marks in the passphrase are misconstrued by the command line as an actual question, not...
Should I bother applying inbound policies on the Dialer1 interfaces? Or should I be applying outbound QOS on my LNS and what might be the best way to do this without giving every single PPPOE user the exact same policy?
Thanks. I had a look at that method and thought their might be a different way to do what I need. Unfortunately policing can only restrict bandwidth in 1 Megabit increments and I wanted to do this in smaller increments. Also, I still am unclear on wh...
