Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
- This is the first time i have setup ASA 5506x FW. I had read some documents that i can connect my PC to interface G1/2 on FW and access https://192.168.1.1 to install ASDM. But after connect to G1/2 on FW, i had no ip address.
- I have...
Hi everyone,
I can't type configure terminal command with my asa 5506, does this command has been replaced to the another command? Any one can explain to me this issue ?
Many Thanks
Hi all,I want to receive email from PI when some one changes the running - config on my devices (Switchs or Routers)How can i do it with PI ??? Thanks for any feedback
Hi all,Can any one can help me on below issueI have Cisco Pi 3.1 , daily i recieve a lot of alarm about link up/down status (hundred larms). I just want to receive status about important links , ex: trunk link. So i changed Interface Alarm policy. B...
Hi everyoneI've problem with Cisco Prime Infrastructure 3.1 . When a port of a switch goes down, the cisco Prime Infrastructre doesn't generates Critical Alarm for that (this is a problem happen with all port) although Interface alarm policy is set...
Hi Hamdi,This is output commands:************************************firepower# show runfirepower# show running-config : Saved: : Serial Number: JAD212706WT: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores):NGFW Versi...
Thanks for help, MarvinThis is the fisrt time i have used Asa FWNG, it quite different with traditional fw so it very difficult for me .Anyway, thanks for your help
Thanks Marvin,As your comment, i can use enable command if using system support diagnostic-cli.So, must i use asdm to configure parametes like hostname, timezone...Thanks for Help
