Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 switches in stack (9300)in ring . stack cable between 1/1 and 3/2 look like disconnected. Can I connect stack cable without make any of the switch down ? I don't have downtime for this task, will it cause stack reload?Switch 1 - master Switc...
I have 9600 core switch on which I am getting "% Authorization failed." error.Only sh run and sh logging output i am receiving.Please find the AAA configuration below.aaa new-model!!aaa authentication login default group tacacs+ localaaa authenticati...
Hi All ,I am getting 169.X.X.X IP in vlan 103.As i checked DHCP pool for same vlan, Pool was not full. aslo there are no IP conflict .as I change the interface vlan from 103 to 104 , system take the IP from vlan 104 and when I revert it back to vlan ...
I am not disconnecting stack member. I just want to reconnect the stack cable between 1/1---3/2.In current case stack connection mentioned below.1/2 -- 2/12/2 -- 3/1
Thanks Joseph for your valuable reply. But I am not going to add or remove any stack switch member ,I am just reconnecting the redundant stack cable. Will it impact the production?
