Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When trying get RPC from IOS XE 17.9.4 c8000v not getting response or error. On hitting enter the netconf session is getting terminated. below configs are used to BN-CP#show run | sec netconfnetconf sshnetconf-yangBN-CP#
Configured OOB IPs for the interfaces in the ACISIM.but I am not able to access them as i am observing the mgmt0 interface in switching disabled state.
I have updated update source of nve1 interface to loopback0 and that worked.LEAF1# show nve peersInterface Peer-IP State LearnType Uptime Router-Mac--------- -------------------------------------- ----- --------- -------- -----------------nve1 40.1.1...
M02@rt37 I am following this doc: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/92x/vxlan-92x/configuration/guide/b-cisco-nexus-9000-series-nx-os-vxlan-configuration-guide-92x/b_Cisco_Nexus_9000_Series_NX-OS_VXLAN_Configurati...
Hi Marco,
The below is screen shot of the cisco
csr iosxe 17.3
which is able to run the command without licence.
whereas
iosxe 17.9
is not accepting the command:
