Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a group of 6 Cisco 1832 access points providing Wi-Fi access for our offices,1 set as a controller for all, all but one are working acceptably.tried troubleshooting to figure cause of connection problem until just recently found that its chan...
Would appreciate help to resolve the above mentioned error as its disturbing network operation, my guess it is due to spanning tree problem though I reviewed it several times but still one switch is showing as root when it should not & tried to chang...
we have in office multiple switches but the POE connecting to the Cisco Aironet 1832i is a Cisco Catalyst 2960s-48, all was working with little problems / disruption until recently a lot of problems began to show connecting to Wi-Fi for several users...
We have several Cisco AP 2802i configured with one AP as controller managing the other AP's, with 2 VLan's, 1st for office use, 2nd for Guest access.All was working fine for several months, then began to see complaints that though WiFi connection is ...
We need to have Firepower 2110 installed for IPsec tunnel with both sites we have dynamic DNS used as no static IP possible for both sites.
is it possible to have Cisco Firepower used for IPsec Tunnel & VPN using Dynamic DNS?
already looked up onli...
Currently for this Access Point we are using 80MHz channel width, it is more of testing what could be a solution for this problem. What also missed to mention that sometimes we only need to restart the Access point & all is working ok again on same p...
Unfortunately not yet, I opened a ticket with Cisco support but still after several weeks not much progresscurrently working with 3rd party network support to see if they can take this forward.
Hi,would appreciate if you could guide on how to check MST version as I am not sure on this part.no manual VLan prune is done, but I fear the MST / STP is some how causing this loop / black holeour current Lan layout spread around 12 Switches/12 Acce...
