Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have many roomkits in classrooms this one room has been kind of stumping us despite not being much different than other rooms as far as size. They had issues with remote people hearing them, added a second mic still same thing, added another no ch...
When we setup the system a number of years ago we enabled network summary alerts that we get in email every week. Or maybe that is just a default i don't recall now. Anyways I created a test network with one WAP for now i used trying to diagnose some...
I am looking at UPS units for some of our IDF closets, I like the more efficient simulated sine wave version UPs, but seems like they occasionally do have issue with some devices. I do not see why it would matter in most cases though because the PSU ...
I am wondering if there is any way in Cisco prime 3.1 (or maybe a newer version) to create port groups based on VLAN settings. I would like to have some way to make port groups based on the port settings. E.G a port with a voice vlan assigned would s...
A number of years ago I did some work on Juniper switches and I remember they had a feature where you could make a change, but if you did not confirm the change in like 30 seconds it was purged. I think this was so that if you cutoff your remote acce...
Thanks guys, prior boss for whatever reason went with the table mics. We looked into did some testing with new boss and he said like 5FT and then even at like 6FT it sounded a lot worse. We ended up re-using a ceiling mic from an old MX MX700 that di...
CS-MIC-table-J so table mic, (TTC5-14) Uses a 3.5 TRRS plug.The ceiling in these rooms is only about 9-10FT so not extreme, room is probably like 20X25 or so size.
Mic is 74-120677-01Yes the new unit was reset to default before and then activated in the same webex space as the old one.All the settings I looked at were in the local web UI of the device.
Ok thanks that is like the last place I would have looked to modify or see any reports we had setup. I assumed it would have been more directly off of one of the main menu tabs or the admin page.
