Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Is there any documents that states methods of load balancing works or not depending on type of operation? like src-ip will not work on L2 etherchannel since it will be based on frames not packets or l3 addresses? Thanks,
Hi All, Im confused with the following documents on how bgp process updates and result on my lab https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/5816-bgpfaq-5816.html#oneFor outbound updates the order of preference is:filt...
Hi, Where can i get support why is our routing to cisco.com, gets high latency compare to our upstream . 1st image: Hop 10 ~300ms (USING our IP block) 2nd image: Hop 10 ~192ms (USING our UPstream IP block)
My goal is to limit traffic incoming from my trunk and access port so i can have symmetric download and upload. I dont know why no hits on my policy map.
Please help check. Thanks!
mls qos!!!!!!spanning-tree mode pvstspanning-tree extend system-...
Hi,“No, it can work assuming the frames on the link are contain IP packets.”Yes frames do contain ip packets, but how do the switch read the ip packets? As far as i know, switch or the l2 operation will only read L2 data’s like physical or mac addres...
I'm using old cisco 2960, im just confused, what happen if i tried to use SRC ip or DST ip as method of load balancing on L2 etherchannel? ofcourse it will not work and no load balancing will happen right?
Hi,So you mean, all filter(filter-list,route-map, prefix list) applied on neighbor will be executed? I thought only filter list or the one who is in first order of the preference.Thanks,
