Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the CML sandbox, the ios-xr is stuck in boot loop. I have tried to increase the RAM to 64GB
https://devnetsandbox.cisco.com/DevNet/catalog/cml-sandbox_cml
Hello All, Here is my topology running Segment-Routing with TI-LFA (Node + SRLG-Disjoint). SR with TI-LFA (Node+SRLG-Disjoint)P2 is running XRv9000 7.1.1Rest of the routers are IOS-XRv 6.1.2Here is the tiebreaker scenario. TI-LFA Tiebreaker (Node vs ...
Hello,I have a setup where 2 IOS-XRv routers are Option-B NNI peers within a confederation.The control plane works fine but the data plane is not forwarding any traffic received from the peer.I ran a 'debug mpls drop' on ASB-18 and at the same time a...
It would be helpful if you share the outputs because what you need is an end to end LSP based on LDP/SR/RSVP in IGP and the BGP-LU across networks on the ASBRs.
Have you tried this:ASR9000/XR: How to reset a lost password (password recovery on IOS-XR) - Cisco CommunityIf nothing works then the router can be recovered with USB boot, easy and definite recovery. Although it is a fresh install so the config gets...
But if this is a limitation of the CML platform itself, then one needs more than 3 times the vCPUs it would require to run 1 node, even on the enterprise platform, unless the enterprise edition is optimized for resource consumption.
Thanks!
