Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have built a simulation network of five routers. The objective is for L3Vpn to carry a single VRF between CE routers across a non-mpls backbone.
Two IOSv CE Routers CUSTA1 & CUSTA2 at opposite ends of the network.Two IOSxr PE routers PE1 and PE2...
I've set up both the External Database and File Store servers for Managed File transfer. I've activated the XCP File Transfer Manager service but on start it fails after several minutes.
I've checked the log file epas/trace/xcp/log/AFTStartup.log and...
I am working on a deployment of Jabber MRA over Expressway.
Our deployment has a single Expressway E and Expressway C.Expressway E has a public IP address._collab-edge A record is present in External DNS. \_uds and _cuplogin records are present in i...
Over the last week, I've seen several clients (mostly windows 7 and Vista, not seen yet on Windows 8.x) having the same problem. When connecting to our VPN services on ASA 5510 running version asa915-k8.binClients are connecting with AnyConnect versi...
We've been using Cisco Jabber desktop client without any trouble for several months. Recently (past two days) I've had a couple of users with 10.5.5 client start seeing the error message "Cannot communicate with the server". This is using the default...
Would a GRE (tunnel-ip) interface using the 0/0/0/1 interfaces on both PE routers as source / destination fit your recommendation? Would I need to adjust MTU (layer 2, IP or MPLS) for MPLS traffic to traverse the GRE tunnel? Thanks for your response.
I've attached a screen capture showing syslog entries from RTMT. Maybe this entry will help the discussion?
Advanced File Transfer requires a database, IDS DB is not valid
I've attached a screen capture showing syslog entries from RTMT: I see this entry in particular that I could use help understanding...
Advanced File Transfer requires a database, IDS DB is not valid
Hi Randy,
You were right about ALG. I disabled inspection of port 5061 and was immediately able to register and make calls. Thanks for the help! Much appreciation here.
Thanks again!
John D.
In addition to the information I just sent here's information about the phone type:
Product Type: Cisco Unified Client Services FrameworkDevice Protocol: SIPReal-time Device StatusRegistration: UnregisteredIPv4 Address: 10.8.18.145Active Load ID:...
