Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to audit approx 300 WLC's using Prime. I would like to have prime verify the Radius servers configured on all the WLC's Prime manages. Can this be done with a report, audit tool, compliance tool? Thanks,
Hello, I'm upgrading Prime Appliance from 3.5 to 3.7. I have Prime setup in an HA role. My question is do I have to break HA when doing the upgrade or can I fail the primary over to the secondary and complete the upgrade on the primary fail back to t...
When I added the channels manually the extended UNII-2 box was enabled. I couldn't find a command to check the box automatically. I had to add the channels via CLI then the box appeared with a check in the box.
I see in the GUI where you can check the extended UNII-2 channel box. but I don't see that option in Prime 3.7 for the template to set the DCA parameters. I was hoping I could enable extended UNII-2 via CLI
Scott, Thanks for the reply. I running ver 3.7.1 which does support the 9800. I'm able to push templates to apply wlan configurations but, I cant set the Wlan ID.
