Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to match this after a reload and it never triggers:event syslog pattern "%CALL_HOME-6-CALL_HOME_ENABLED: Call-home is enabled by Smart Agent for Licensing."Can someone provide some insight into why my applet doesn't trigger? I can plainly ...
I have a layer 3 port with an IP of 192.168.1.1/24 on a iosv l2 image connected to a layer 2 port on a osv l2 image. The layer 2 port is access and allowing vlan 10. There is an SVI with vlan 10 with an IP of 192.168.1.10. I can't get the two IPs to ...
I have a pair of 6800's in production that I'd like to replace. It's currently configured with the management on two regular ethernet ports using the backup interface command on the B side. This is to support Netflow since the Netflow exporter won't ...
Can the Mgmt-vrf VRF be used on an SVI on a C9606?I have a switch setup to use the management interface with the Mgmt-vrf as the VRF on g0/0. I want to setup Netflow, but Netflow doesn't export from g0/0. I was wondering if I could setup an SVI and a...
I'm getting multiple of the following errors when my EEM policies run:%HA_EM-3-FMPD_UNKNOWN_ENV: fh_parse_var: could not find environment variable: state%HA_EM-3-FMPD_UNKNOWN_ENV: fh_parse_var: could not find environment variable: ipI get both when B...
This is probably the issue. It runs with the @Reboot. The problem is the timing. The script runs, but then the call-home features are enabled between the script running on reboot. How do I delay it say 60 seconds or so? If I could increase the maxrun...
I changed the event to none and manually triggered it. It ran and event manager statistic policy shows that it triggered once. I was missing the cli command "enable" to make the applet do what I want it too, so I added it and triggered it again. The ...
I've tried:event syslog pattern ".*%CALL_HOME..."with the ellipsis replaced by the entirety of the string from logs previously. Doing it again and reloading to see what happens.
