Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,when we update the MX Firmware from 19.1.12 to stable Firmware 19.2.7, we get DNS_EVENT_BAD_PACKET_LENGTH (Event ID 5501) and the oversized DNS packets (EDNS0) are thrown away.Had anyone the same issue in the past or yet and a solution for this be...
Hi,we have a Multi WAN Setup, ISP 1 on MA-SFP-1GB-TX WAN1, ISP 2 on MA-SFP-1GB-TX WAN2, ISP 3 on WAN4 as Backup.We have observed, that WAN 1+2 fails on come up (up only for a shot time) due to halfduplex (1/10G on local Status page, 1G fixed is the s...
Hi,I've updated a few site with MS 18.1.1 Firmware. I have observed that all wireless clients connected to CW9162I didn't get a DHCP addresses from the DHCP Server, but this happens onyl on MS130 Switches. All other MS225, MS250, MS425 with same AP's...
@CMR We are using MX250,MX105,MX95,MX85, all MX's have transit net to Meraki Layer 3 Switches (MS250,MS355,C9300L,C9300,C9300-Y), all depends on the size of the branches. Servers are connected to the Layer 3 Switches, Clients to Meraki MS225,MS150,MS...
We have the problem with all 19.2.x and 26.1.x firmware verions, that wireless and wired clients don't get the local DNS informations provided by the Windows 2022 DHCP Server. With older 19.1.12 Firmware everything works fine. All clients use the loc...
We habe nearly the same problems. Which FW do you have on the MS130 ?If you run the FW 18.1.x on MS130, please try it with FW 17.2.2 and observe, if the client connection problems still exists. Our problems gone with FW 17.2.2. On other switches tha...
