Hi, I currently have 2x 9800s in HA SSO and want to update from 17.6.4 to 17.9.4a, I cant seem to locate a guide for the process when setup in SSO. This WLC is in DNA Center but I think I'll prefer to not use DNAC or ISSU and do this upgrade manually...
Hi. I recently attempted to update 2x C9500 in SVL via DNAC from 17.6.4 to 17.9.4. It initally looked to be progressing all ok with being distributed then activated on each unit. DNAC then stated process had failed. I manually checked switches via CL...
Hi Everyone, I'm currently in middle of a rollout of Cisco SDA across our estate incorporating Cisco DNA Center, ISE, ACI etc. Its going well :). Most of my sites are either private fiber or leased circuits which have been migrated to Cisco without a...
Hi, hoping for some advice. New to SDA and fusion routers, have an issue whereby a VRF is unable to route to my legacy OSPF networks (to/from) on the fusion nodes which host the default routes so all OSPF traffic is following default route and being ...
Hi Everyone,We recently enabled our Trustsec matrix and applied CTS configuration across estate, its working well all apart from via 1 Border whereby since enabling End user devices connected via here lose connectivity for just 1 or 2 pings at 2am'is...
@Leo Laohoo - thanks, the guide will definitely come in handy, in this instance I have arranged WLC downtime over a weekend so will just be letting it reboot when asked after 'install add bootflash:xxx.bin active commit' command.Rich R mentions the ...
Thanks yeah I'm aware, the SMU will be installed once main package is showing all ok. Think we had just started rolling out 17.9.4+SMU before 17.9.4a was released. We'll probably move to the next recommended release in near future. Cheers
@Leo Laohoo yeah that's looking all ok, ok I'll arrange a full reboot hopefully tomorrow, tempted to do it now but this 9500 is acting as a fusion router so quite a few 24/7 offices connected so will need to arrange. Thanks for the advice. Will let ...
Hi again @balaji.bandi ... had a change request to try and resolve this tonight, first i reran 'show install summary' oddly it now shows Chassis 2 as Committed and Chassis 1 as Uncommittedshow install summary[ Chassis 2/R0 ] Installed Package(s) Info...
