Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we are planning to deploy catalyst 9500-48Y4C as new core switch in our office. What is the best practice to connection stackwise-virtual links and dual-active-detection links? use uplink module 100G ports with DAC or use normal ports? Are the fi...
Hi, we have configured netflow on Catalyst 9300 switch, but seems it does not send traffics to Solarwinds. We have configured NTA for this switch. But solarwinds never receive any netflow traffics. Below is the netflow config on C9300. Can someone pl...
Hi, we want to setup Meraki wireless in our office. What firewall rules should we configured to allow Meraki Access Points to communicate with Meraki cloud.?
hi, we have one new cisco catalyst 9350-48U switch, it is locked out because aaa is configured, but local account has not been created, so now can't login via console and need to factory reset it. I follow following instructions, but the switch didn'...
Thanks @David Ruess for your kind advice. can see a lot traffic flows by running this commands, so it really collects data. I have tried to configure monitor on VLAN interface rather than the trunk port, but same result.
Hi @Amrinder.Singh , can I ask you one question? why the destination of NTP service is 0.0.0.0/0 in the firewall rule? is the IP of Meraki NTP server keeping changing? thanks in advance!
