Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HELP HELP HELP Need help to connect NETWORK A and NETWORK B. NETWORK A :1.Endpoints - Total 20,000 endpoints including 12000 cameras and SOC workstations.2.Cisco ISE 2.43.IGMP V24.OSPF is used as IGP.5.iBGP neighborship is formed from all Site A/B &...
We have around 500 Cisco 3850-48-FS and 3850-12-S switches,IOS 3.07.05 in our environment.In 100+ different rooms they are installed as a stack as per the room requirement.Now we have to remove few configurations from switchports of all the stacks.Is...
Hello all,
I want to automate detection of the mac address of the device and assign the associated port to a particular vlan on Cisco 3850 version 03.07.05.E.Is there any way to do this like EEM scripting or any other solution.Please note that we u...
Hello all,
I want to deploy flexible netflow in our network where cisco 3850 is at access layer and Prime 3.3 will be a collector.Need help with the configuration on switch.cisco 3850 with two uplinks configured as a L2 port-channel is installed as...
Hi Georg ,The devices we are using are mentioned in the right corner of the drawing and all PEs and Site devices are acting as L2/L3 devices.Regarding configs i'm really sorry as i can't share them here in public platform.But i've provided more infor...
Though i have already gone through those scripts available on internet and tested them but all were unsuccessful.So i'm looking for the configuration template to test if someone has implemented this successfully.
Currently we don't have a 802.1x .What i want to achieve is detect the mac address with particular OUI on switchport and configure the associated vlan on that interface.
So now i understood that i don't need have to apply flow monitor on switchports but both uplinks are L2 portchannel and we are using different management vlan.Management vlan have it's SVI through which Prime is reachable and as i've tested we can ha...
