Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, For archive configuration feature, is it possible to change the vrf management by another vrf ? The TFTP and FTP for this feature use VRF management. I have to use this feature but with another vrf for working. Regards.
Hi Guys, After read some Cisco documentation, I have questions for you about the relation between 802.1x and DACL. If I want to push DACL on a Cisco Switch from ISE node, do I need to enable 802.1x command on the switch ? In fact, I'm asking me which...
Hello everybody,
Today, I scanned my router with Nmap in order to check the opened ports.
Two ports are opened/filtered :
-28112
-49208
I didn't see these ports when I launch sh udp & show control-plane host open-ports on the router.
Router...
Hello guys,
Currently, each user's port on an access switch receive HSRP frame and for best security we would like to filter/block HSRP packet.
Is it possible ?
In attachment an architecture example.
Thank in advance.
Hello guys,
Q. Do I need to purchase licenses for every node in a Cisco ISE cluster or deployment?
A. No. Cisco ISE license files are uploaded to the primary Administrative node, and the node propagates the licenses to all the nodes in the cluster...
I tested on a physical Nexus switch, NX-OS 9.3.3. As below my test with login/pwd and without login/pwd :First test : the login or pwd are incorrect but I verified, i'm connected with the same account to the ftp server so the credentials are OK.Seco...
It's not allowed to use login/password in this command. If manually transfer file to ftp you should use "copy running-config ftp://ftpusername@ftp-server/" , then type password manually. I couldn't find any way to use ftp for automation backup till n...
Hi Dawei, Thank you for your solution, but I'm facing an issue because the FTP server use account with credentials.And it's seems that the command copy running-config ftp://ftpusername:ftpuserpassword@ftp-server/cisco-device/switches/$(SWITCHNAME)-c...
Hi Clark, I added a comment on this post about your question => https://community.cisco.com/t5/routing/does-cisco-support-strong-remote-network-authentication/m-p/2767297/highlight/false#M257295I think I reply to your answer. Regards.
