Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to configure 2 PE router that is customer's locations connected to give customer dedicated bandwidth. there is 1 P router between PE routers. So what kind of configuration I can make to give one vpn customer to dedicated BW. I looked for M...
hi,some platforms like 7500 series, are not accepting mtu command for fastethernet interfaces. If you use the box for mpls, you have to set mpls ip mtu for label positioning. In this case you can change the IP mtu without changing interface mtu. but ...
hi hritter,thank you for answer. Would you give feedback about IOS. We are currently using 12.2 series. Do we have to migrate to 12.3 or going with same IOS to the migration?
hi,trying to resolve this kind of attack with bgp makes it harder. because if prefixes increment, router break down the bgp peering. gets routes again,and it will pass the values again. this kind of configuration can consume router cpu. so it may sto...
hi, you can use flavour of random detect. make the low water mark and hitgh water mark values higher and random detect probability would be 1/20 or lower. like thisclass citrixrandom-detectrandom-detect 1 150 200 20random-detect 2 150 200 20etc...re...
