Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all!
I'm doing CCNA, and building my router-switching lab. I want to add WiFi links to my routing experiments, so I'm looking for to buy a hwic-ap module or a separated access point such as Air-ap1231g-a-k9; Air-ap1242g-a-k9, to say some afor...
Hello All,
I'm looking for documentation, firmware, etc for an old Cisco 2505 router. It has 8 ethernet ports, behind. I've searched on cisco.com but there is no much data. Is there some FTP site from Cisco, as happens with some other big companys?...
Thank you a lot, Flavio! I know that real lab is not necessary, but I like to work with hardware too. Anyway, there is several commands that are not the same with Packet Tracer.
The APs are using a complete ios operating system? Or is another versio...
Hello Brad, thank you for your quick response.
I thought that could be compatible because in Packet Tracer, the NM-2E2W appears as available, and works, for the 2811.
Thank you!
Kind regards,
Mariano
Hello!
I have two routers, Cisco 2811 and 2821, and want to add two extra eth ports. So one alternative is the NM-2E2W, I would like to know if this board is supported by that routers.
Somebody answered your question, but he misinterpreted the model...
