Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Current set up is:1 - 4402 - 50ap WLAN Controller with code 4.2.130.01 - 2125- 25ap WLAN controller with code 5.2.15735 - AP1010 access points17 - 1100 series access pointsI've told each access point which controller is its primary controller but aft...
I have a Cisco AIR-AP1131AG-A-K9 wireless access point. This AP is an autonomous (stand alone) AP not used with a wireless controller. I used Cisco's upgrade tool & the correct image to upgrade the AP to LWAPP (so it could be used with a Cisco wirele...
Hello,I have 2 cisco 3550 switches. I have 2 vlans, VLAn1 & VLAN3. I have 3 ports on vlan 3 & all others on vlan 1. I need to grant access to 2 ports that currently are on vlan1 access to vlan 3. In essence, I need to know the CLI commands to grant 3...
I have a problem & I can't figure it out to save my life!!! I have a Cisco 3550 switch with 1 VLAN. The VLAN is named VLAN 1 with ports 0/10, 0/11, 0/12. 0/13 in it. I have an ISA server on port 0/2. Any of the computers that are in VLAN 1 (in the po...
Yes, the only way I figured out to keep from having c0-channel interfernce with neighboring APs on different controllers is to power down the 2125 & reboot the 4402. Then 50 of the APs (all the 1010 series) will connect to the 4402 & the few others w...
Thanks leolahoo,I'll try this & see. TAC is also stumped on this one after logging into my controllers & seeing for themselves. They've been working on this for 3 days.... but I don't think they've done this.
A few questions first:Is your enterprise DHCP server a Microsoft Windows DHCP server?Is the DHCP server giving leases withing a LAN or across the WAN?Is it the same WLC doing this all the time or is it different ones every 30 days or so?
