03-31-2005 04:56 PM
Can I configure an ACL on a Cisco 3550 Catalyst switch? If so, is there anything special I need to configure on the switch other than the ACL?
03-31-2005 07:30 PM
The Catalyst 3550 does support ACL's. Please refer to the document at the link below for more information about the types of ACL's supported as well as configuration information for them. Once you have the ACL defined, all you need to do is apply it.
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225se/3550scg/swacl.htm
HTH
Steve
03-31-2005 07:42 PM
Can I configure an ACL on a Cisco 3550 Catalyst switch? Yes.
Here is the complete book on the 3550 Switch configuration guide: http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_book09186a008040c4a1.html. Skip to this bit http://www.cisco.com/en/US/products/hw/switches/ps646/products_configuration_guide_chapter09186a008031ffd9.html which is the "Configuring Network Security with ACLs on 3550s" section.
Cheers,
Josef.
PS - rate if it 'elps...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide