About fromthesky

fromthesky · 07-01-2012

Hi, I would like to implement VLAN ACL on a layer 3 switch for filtering traffic between servers in the same VLAN. I have a doubt: I have several virtual server in this VLAN and I wonder if the VMware virtual switch will allow the virtual servers to ...

fromthesky · 11-18-2011

Hi, in order to restore all the virtual contexts of a failed firewall module is it sufficient to apply the failover configuration of the system context? If yes, is it possible to do it for restoring the primary or the secondary module indifferently?t...

fromthesky · 07-30-2010

Hi, I would need some clarifications about rogue AP detection. First, in order to configure the passive rogue detection is it necessary to just setup a rogue detector AP or I also need to enable RLDP? Second, in your experience how much is it reliabl...

fromthesky · 04-30-2009

Hi all, i'm going to upgrade a pair of WLC with a very old software image. Since this situation requires several intermediate upgrades, I was wondering if I can disable the distribution ports at the begining of the upgrade and then enable them at the...

fromthesky · 09-15-2008

Hi, an our custumer as an old C2900XL switch, with IOS 12.0(5.2)XU installed on it. The switch is in VTP client mode.I noticed that on this switch the STP has been disabled for some VLANs (don't ask me why, it was configured before my company started...

fromthesky · 08-07-2021

This is an old post, but in case someone have the same problem (like me ) you already checked basic connectivity and you are using an enterprise CA, the cause is probably that the vSmart do not get the CA certificate from the vManage. You can find a...

fromthesky · 08-07-2021

I had a the same problem and I solved it this way:- copied the CA certificate from my PC to the vSmart via SCP (the certificate will be copied in the home of your user on the vSmart. You can list the content of the directory going in vshell- installe...

fromthesky · 12-31-2019

Hi, in case someone would need to keep a debug active for a while, there is a workaround: set the anti-idle feature in your SSH client.

fromthesky · 06-01-2015

Hi, what's the purpose of the routes above? These routes don't look correct as the next-hop is in the network of the route. Also, these networks are directly connectd.Regards,

fromthesky · 04-19-2014

Hi, why use the "set interface" keyword? Shouldn't it be the "match interface"?Thanks,

Member Since	‎11-25-2003 10:30 AM
Date Last Visited	‎11-05-2024 07:53 PM
Posts	28

User Statistics

User Activity

VACL & VMware

Restoring failed firewall module with multiple contexts

Rogue detection

WLC Upgrade & AP

Could not enable spaning tree on some VLAN

Re: vsmart registration

Re: vSmart does not get enterprise root certificate from vManage

Re: ASA debug removed when closing session

Hi, what's the purpose of the

Hi, why use the "set