Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I have an ISR 4431 with CME 14.1 installed and I managed to get a intercom/trunk (hotline) working on a CP 6901 (SCCP) in telephony service, but i couldn't manage to get it on a CP 7821 (SIP) because i get the message " Can't configure in...
Hi everyone,I have an ISR 4431 with CME 14.1 installed and 2 IP Phones (Cisco 7821). The phones are getting an IP from the DHCP server but aren't registering.I've attached the configuration file, a debug file and pictures of the phones.I've tried fac...
Hi everyone,I am trying to expand my existing VoIP network that uses a CUCM 11.5 to another location using a newly bought CISCO isr4331/k9 but I've never configured an isr4331/k9 and don't know how to proper make use of it.I need to install 80 Cisco...
These 2 phone are the only ones at this moment. But they are still not registering, doing a show voice register pool all brief - they are still status unregistered and on the phones I get the message registration in progress...
I your tftp-path under voice register global as "tftp-path flash:" but further down in the config you have command starting with "tftp-server bootflash:" Is this correct? ---- Yes. It doesn't allow me to put tftp-path bootflash: . If you have anothe...
