About Godwin_S

Godwin_S · 07-21-2020

Hi Friends,I am trying to explore Cisco Webex REST API with Python and somehow I am stuck in Authentication error. I have successfully created token ID(just mentioned 'xyzxyz' as refernce) , but not sure how to input in GET request. Can someone help ...

Godwin_S · 04-27-2020

Hi All, I have a small doubt and need your help to clarify it.I know that in multicast PIM sparse mode, the multicast traffic will be distributed only if receiver request for it. While receiver send IGMP report message L2 switch will learn the multic...

Godwin_S · 07-04-2018

Hi,I have a small doubt regarding NAT ACL. Below is my config sample. When traffic initiated from 10.10.10.1 to 172.16.1.1, no translation happening due to ACL 200 being get hit. Is this a normal behavior of NAT? Do we have any documentation regardin...

Godwin_S · 06-13-2018

Hi, I have a small doubt from below NAT translation output. I only do outside nating here. My Questions: 1) If all three sources initiate traffic to 172.16.91.130 at same time, can this static nat be translated for all three flows? 2) If only first ...

Godwin_S · 01-17-2017

Hi, Can someone help me how to check connected lines on terminal server? Not the active open session. Just want to check which lines are all connected to network devices console port.

Godwin_S · 04-28-2020

Hi Sergiu,Thanks for your explanation. I still would like to have more clarity. Let me put my query in steps.In Dense Mode:Step1: Last hop Router(Router 1) receives multicast traffic and look for (S,G) and initially router will have all PIM interface...

Godwin_S · 04-27-2020

Hi Sergiu,I am clear on the answer for question 1. Thanks for that. Reg Q2, does it mean regardless of listeners present or not, Router keeps sending IGMP member Query message and keeps pruning? Reg Q3, as you mentioned IGMP will be enabled along wi...

Godwin_S · 10-02-2016

Hi gpauwen, Thanks for your reply. My concern is this. Lets sat I have x.x.x.x subnet on area A. To advertise x.x.x.x to area B ABR use to generate LSA 3 for x.x.x.x and flood it to area B and it should not flood to area A. In my topology I have 3...

Godwin_S · 02-23-2015

Hi mohanak,I did reboot the primary instance and it fixed the issue.Thank you very much.

Member Since	‎02-19-2015 11:14 PM
Date Last Visited	‎07-28-2020 11:14 AM
Posts	11

User Statistics

User Activity

Cisco Webex Python Request Authentication Header

Multicast Dense Mode vs IGMP snooping

NAT ACL conflict

Multiple entries for Static NAT

How to check Cisco Terminal Server Connected Lines

Re: Multicast Dense Mode vs IGMP snooping

Re: Multicast Dense Mode vs IGMP snooping

Hi gpauwen,

Hi mohanak,I did reboot the