Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have frp 1120 configure with single interface and 5 subinterface, where one goes into the switch secong goes onto the FTDV 1 and third is to FTDv 2 and other two DMZ on the router. Access policy is proven to be working as it was operational ...
Hi All,I am trying to replace my Meraki switch with C9300 but keep Meraki AP.First step was to replicate settings and apply to the C9300, however Meraki AP isn't able to resolve dnslookup on tagged traffic but all is fine on untagged traffic. DHCP se...
Hi All,I have replaced my Meraki switch with Cisco C9300 and replicated exactly same configuration which is proven to be working on meraki device including wireless AP, however once I switch with C9300 no DNS relies coming from google DNS onto switch...
Hi All,My task is to replace existing mx device with 1120 and connect to the MS350 upstream, which is cloud managed and requires access via VLAN1. 1120 ia managed via Cisco FMC. Giving that, I am unable to implement VLAN 1, which is necessary for Mer...
Hi All,I am trying to replace my exiting mx67 with cisco 1120, but leave upstream swich MS 350.Cisco 1120 is managed by cisco FMC, where I have managed to assign an outside interface with ISP details and on inside two sub-interfaces, one is VLAN1 and...
Thank you for your advise.It appears that issues was with the switch, as ip routing wasn't enabled, and after enabling it routing start working as expected.
