About duncan_watson

duncan_watson · 08-10-2009

With the following config... policy-map COS class IP-PREC4 set ip precedence 4 priority percent 50 class IP-PREC3 set ip precedence 3 bandwidth percent 30 class class-default fair-queue random-detect policy-map SHAPING class class-def...

duncan_watson · 08-09-2009

Layout as follows:(Site office)Analogue Handsets->PBX->EM Trunk->Voice Gateway--->IP(SIP)--->Voice Gateway->T1 Trunk->Digital PBX->Digital Handsets(Head office)Problem:1. Calls made from the head office digital handsets to the site office analogue ha...

duncan_watson · 07-16-2009

I have an issue making 2 or more calls within a short space of time between two phones, one native IP behind a CME running 7.0.0.1 and the other behind a 2811 router with a basic H323 voice gateway configuration.The (edited) configs for each end are ...

duncan_watson · 07-16-2009

I have an issue making 2 or more calls within a short space of time between two phones, one native IP behind a CME running 7.0.0.1 and the other behind a 2811 router with a basic H323 voice gateway configuration. The (edited) configs for each end ar...

duncan_watson · 04-01-2009

Hi,I put this question to a CCIE friend of mine, but as we couldn't come up with an answer between us I thought I'd push it out to the netpro community.Basically, we have a 2851 running CME 7.0.0.1, and it works fine until the router is reloaded or t...

duncan_watson · 08-11-2009

Thanks Joseph. Where did you get this info? I've tried to find something definitive on the Cisco site regarding this but no luck to date.Unfortunately it's a provider router (CE) so I don't have telnet access, but I do have GN3 so I'll give it a tr...

duncan_watson · 08-11-2009

Gotcha. Thanks Istvan.Duncan

duncan_watson · 08-10-2009

Nick,Many thanks for your reply.I changed the Type to 5 (from 1) and that fixed it. Our PBX vendor was swearing blind the settings matched, just thought I'd give it a try all the same.Anyway, appreciate your response.Duncan

duncan_watson · 07-16-2009

Nick,The 'session protocol sip' command fixed it. Many thanks.If you have a second, could you please explain your above answer, 'since it would be UDP by default' in a little more detail?Many thanks again,Duncan

duncan_watson · 04-01-2009

Many thanks Edison, I think that's what I've been looking for.I'll give it a shot during the next service window.Duncan

Member Since	‎04-01-2009 12:41 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	12

User Statistics

User Activity

QoS - priority percent

Calls through PBX via E&M Trunk drop after 3 minutes

Call Failure (H323)

H323 Call Failure

2851 Not Executing Config Correctly from NVRAM

Re: QoS - priority percent

Re: QoS - priority percent

Re: Calls through PBX via E&M Trunk drop after 3 minutes

Re: H323 Call Failure

Re: 2851 Not Executing Config Correctly from NVRAM