Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have existing wireless setup which i am trying to understand . As per inventory list in office we should have 2 2504 wireless controller . But i see only one WLC connected on network . When i login to one of the box I see virtual ip configured 1.1....
hello ,
I have cisco 1841 installed as remote console connecting device for all. the network devices using the
"HWIC-8A@" all the devices are connected , when I do show host I see the tty host but when I telnet to any of tty it says connection refu...
hello ,
I have new 3850 stack added to network
we have local enable secret on the device which works fine even for remote management.
But when I add the tactics key the tactics credeteinals takes me to user level but doesnt work on enable level ...
hello we have a 3750 cisco switch , need to built a setup with 2 vlans vlan 10 with subnet 172.16.20.0/24 gateway ip address is 172.16.20.1 which is on firewall which is connected to uplink port eth 1/1 on 3750vlan 20 10.10.10.0/24 with gateway 10....
hello we have ACS server in our network which is currently used for wireless controllers we need to add network switches to authenticate from ACS server. I have prepaired some config but I am not sure if thats right I have two set of config do tell ...
hello Thanks thats really helpful , I see both the controllers there , from initial setup for another site if I have to have 2 WLC can you please advise I need to configure both of them with similar paraments and connect to network if there is a gui...
Apology for confusion and taking your time , Just wanted to know with below config which was prepaired for first time what configration i need to give on interface gi0/0 which connects to firewall please thanks ---------------------------------------...
Thats right want to keep vlan 20 layer 3 on 3750 . So below is the only configration i need to do on 3750 on port which connects to firewall ?int gi0/0 <-- this connect to the firewallno switchportregardsAmit
Thanks Jon , One more thing , in the first solution I need to put the trunk port config on 3750 right ?Gi0/0 connects to Firewall int gi0/0 <-- this connect to the firewallno switchportswitchport mode trunk aloowed all is that right ?regardsAmit
