Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am looking to expand our current Wi-Fi infrastructure and need some guidance on compatible Access Point models. We want to add more APs without replacing our existing controller setup.Current Environment Specs:Master AP (Controller): Cisco Airon...
Hello,I am looking for a NetFlow analyzer that can display and report statistics using the Post-NAT Destination IPv4 Address.For example, I’d like to monitor the download traffic of each individual end host based on their internal LAN IP addresses. H...
Hello,I want to block the traffic between hosts in the 10.120.0.0/24 network at Layer 2.For example, on my Cisco ASA I have a VPN pool configured from 10.120.0.0/24 and users are connecting with these IP addresses.In the logs I see entries like:Teard...
Hello,We have seen that Cisco devices are affected by the vulnerability described here: https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asaftd-webvp…and here: https://thehackernews.com/2025/09/urgent-cisco-asa-z...
Hello,We have bought Cisco 8000V Edge Software with DNA Advantage 1 Gbps Subscription.I have some questions about it:1. As i know, download traffic coming into the router is unthrottled (Rx is Unthrottled). Is it correct?2. Also as i saw, Transmitted...
We have both Cisco and MikroTik routers in our network, and we’d like to collect NetFlow data from them. The NetFlow tools we’ve tested so far only display the Destination IP Address, which in our case is the public IP. Because of this, we’re unable ...
Thanks for your response.What do you mean by “product”? Are you referring to the NetFlow Analyzer? Could you recommend one suitable for this kind of scenario?
group-policy IT-Dep internalgroup-policy IT-Dep attributesdns-server value 172.26.13.11 172.26.13.12vpn-filter value Deny_Policy_For-Anyconnectvpn-tunnel-protocol ssl-clientsplit-tunnel-policy tunnelspecifiedsplit-tunnel-network-list value AnycIT-Dep...
Result of the command: "show vpn-sessiondb anyconnect filter name user1"Session Type: AnyConnectUsername : user1 Index : 697225Assigned IP : 10.12.0.86 Public IP : 202.7.2.19Protocol : AnyConnect-Parent SSL-Tu...
I have a Group Policy – in the Filter section, a Deny_policy-for AnyConnect is configured in the ACL manager.In a separate access list, it is specified that traffic coming from 10.12.0.0/24 on the mentioned interface should have the source services b...
