Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,Can anyone tell me if Multicast MoH is supported over a SIP Trunk from CUCM 7.1 --> 2911 gateway (Cube IOS 15.0) --> ISP SIP proxy.At the moment we can get unicast MoH via the SIP Trunk.If we set the SIP Trunk to look at a Multicast MoH sou...
Hello All, I have run up the Mobile 8 client and connect via IPSEC VPN, the first time I kick off the mobile 8 client it connects just fine and I can send and receive calls. If I then close mobile 8 and open it again, it fails to connect. Any ideas ?...
I upgraded a PIX 515 from 6.3 to 7.22 and after the upgrade static NAT fails for the NAT translations using the same IP as the outside interface. I see the connection being dropped before it hits my outside access-list with PIX7-2-710002 tcp drop ip ...
I have a router connecting to a Fleet77 which presents two interfaces, ISDN BRI and ethernet.The client wishes to use the ISDN as the prime interface to their ISP with the ethernet (20k) as a backup if the ISDN fails.Anyone got an ideas on the best w...
Hi All,Just working on LDAP sync, we currently have CUCM8.5 / UCCX 8.5 found your posts interesting and helpful thanks.Just on the last topic I think the axladmin user (in our environment) is a Application User so I don't think you need it LDAP. Or ...
Logged this with TAC and the answer:Multicast MOH is currently not supported in CUBE. Cube will convert the multicast stream into unicast.The support for M-MOH on CUBE will be available in PI16 release IOS (15.2PIA16 release). The project name is Car...
Hi Jonathan,I don't see CUCM send the multicast address, is there something I've missed in CUCM config ?v=0o=CiscoSystemsSIP-GW-UserAgent 5724 9261 IN IP4 192.168.248.6s=SIP Callc=IN IP4 192.168.248.6t=0 0m=audio 16948 RTP/AVP 8 101c=IN IP4 192.168.2...
