Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I have some AP's that spam my DNA Center alert inbox and was wondering if there's a way to selectively disable certain alerts. For example I get a lot of coverage hole alerts from AP's that are at the perimeter of a location like an exit door....
We have 2802's running 8.3.x code and a fleet of wireless comm badges that operate in 5ghz only. The vendor says to disable FRA which I did but I still see these things connecting to AP's that have the slot 0 radio in 5ghz mode. I would like for the ...
Just fired up a brand new 9300 24 port switch to configure and after the boot process finishes the three cooling fans on the back seem to be constantly varying their RPM's. They'll speed up then slow down then speed up then slow down... over and over...
Stumbled upon an odd issue. I have a 5508 running 8.0.133 with 2702i AP's attached. According to Prime 3.1 I see clients connect to AP1 then 25 minutes later connect to AP2 then 25 minutes later connect back to AP1. This goes on over and over and ove...
I am deploying new 2700 series AP's to a 5508 but I want them to disable their radios when they first connect. Reason being is these new AP's are being installed in a live environment with old 1200 series AP's connecting to WiSM blades and I don't wa...
Thanks! I created a custom profile then applied it to the site where the MRI Trailer AP's are located so we'll see if that works when they relocate the trailer tonight.
Thanks for the reply. Sorry, I've been away for about three weeks and didn't have an opportunity to respond sooner. The SSID is hard set to 802.11a only but the issue is certain AP's are broadcasting 5ghz on both the slot 1 and slot 0 radio in effect...
I'm just going to let this go for now as the internal temps are good and the fans are showing as "Ok". This is my first go-around with a C9300 but I've got over 120 arriving next month so I'll see how those behave. I pulled one modular fan at a time ...
Hi. I see this thread is a bit aged but I had the same question and noted there was no final answer. Go to Report Launch Pad / Device / Detailed Hardware / New Detailed Hardware and select Switches and Hubs for the report type. The report will show ...
Thanks for the reply! I've been doing some more digging and found that the Session Timeout value is set to 1440 seconds (24 min) instead of 14400 seconds (4 hours) so I think that also explains why I see clients connecting for 25 min +/- then re-asso...
