Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded a UCS B series system from 2.1(2a) to 2.2(3d) and i've receiving some errors and I was hoping someone could help me resolve them. Below are the errors i'm seeing. - Code F0315 - Service profile failed to associate to server- FC uplink down...
I ran into a issue today that is bugging me. I'm running a GRE IPSec tunnel from my hub site to a spoke router. In the router I created an access list referencing the Inside global addresses on both sides of the tunnel (Running NAT) and ran debug ip ...
Two companies are merging with identical address space. Company A needs to talk to servers on Company B side with the same addresses and vice versa. What steps from both the NAT and routing perspective need to take place in order to establish bi-dire...
Below is a debug from an IOS router. The VPN comes up and encryps/decrypts traffic fine. The IPSec SA lifetime is 3600 seconds. In the output below you will see the IPSec SA attempt to renew and fail. I put some of the output in bold that I'm unfamil...
Here is the equivalent. interface Gig0/0/1 service instance 25 ethernet encapsulation dot1q 25 rewrite ingress tag pop 1 symmetric bridge-domain 25interface Gig0/0/2 service instance 25 ethernet encapsulation dot1q 25 rewrite ...
I ran into the same issue. My first two attempts came back declined and my third on a different card was successful. I called my credit card company this morning after reading this thread to find out the two declined transactions were charged to my c...
The point to point link needs to be on the same subnet to communicate and route properly. Recommend using a /30Example.R1 - S1/0 - 192.168.10.1 255.255.255.252R2 - S1/0 - 192.168.10.2 255.255.255.252
On all 3900 and 2900 series routers you can only login in with the default login of cisco/cisco ONE time. You must then set a password and save the configuration in order to be able to log into next time. If not then you will have to do a password r...
