borek
Level 1
Level 1
Member since ‎07-30-2002
‎08-18-2017

User Statistics

  • 56 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
20 Replies
10 Replies
5 Replies

User Activity

We have Cisco Catalyst 6500 VSS switches running IOS 12.2(33)SXI14. To my utter amazement I found that these switches seem to no support CISCO-STACK-MIB even if they should (according to MIB Locator). spam@l5nets02:~$ snmpwalk -Lf /dev/null -Pd -OX -...
2015 Sep  2 09:34:11 strS91 %VSHD-5-VSHD_SYSLOG_CONFIG_I: Configured from vty by  rborelupo on 172.20.113.120@pts/0 2015 Sep  3 12:24:13 strS91 last message repeated 1 time 2015 Sep  3 12:29:52 strS91 last message repeated 1 time Can the "last mess...
Cisco 2821 router with VWIC2-2MFT-G703 (a 2-port G.703 card), ISDN switch type is NET5, no DSPs are installed, IOS 15.0 I am trying to configure ISDN PRI for data calls only (no voice), but I get following error: vtpR01t(config)#card type e1 0 2 vt...
I need to find out, with SNMP, what media type (RJ45, FO) and transceivers (SFP, XenPak ...) do ports on my Catalysts 6500's use. What MIB should I look at? I tried to find this info by browsing MIBs with SNMP Object Navigator, but no luck so far.
When I configure an OSPF router with "default-information originate always", that router starts to unconditionally announce 0.0.0.0/0 route -- but the router itself will no longer have 0.0.0.0/0 router from other router(s) in its route table. See fol...
Community Statistics
Member Since ‎07-30-2002 01:36 AM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 56
Helpful Votes Given To