We have Cisco Catalyst 6500 VSS switches running IOS 12.2(33)SXI14. To my utter amazement I found that these switches seem to no support CISCO-STACK-MIB even if they should (according to MIB Locator).
spam@l5nets02:~$ snmpwalk -Lf /dev/null -Pd -OX -...
2015 Sep 2 09:34:11 strS91 %VSHD-5-VSHD_SYSLOG_CONFIG_I: Configured from vty by
rborelupo on 172.20.113.120@pts/0
2015 Sep 3 12:24:13 strS91 last message repeated 1 time
2015 Sep 3 12:29:52 strS91 last message repeated 1 time
Can the "last mess...
Cisco 2821 router with VWIC2-2MFT-G703 (a 2-port G.703 card), ISDN switch type is NET5, no DSPs are installed, IOS 15.0
I am trying to configure ISDN PRI for data calls only (no voice), but I get following error:
vtpR01t(config)#card type e1 0 2
vt...
I need to find out, with SNMP, what media type (RJ45, FO) and transceivers (SFP, XenPak ...) do ports on my Catalysts 6500's use. What MIB should I look at? I tried to find this info by browsing MIBs with SNMP Object Navigator, but no luck so far.
When I configure an OSPF router with "default-information originate always", that router starts to unconditionally announce 0.0.0.0/0 route -- but the router itself will no longer have 0.0.0.0/0 router from other router(s) in its route table. See fol...
First of all, let me repeat the question I have: "Why does OSPF's 'default-information originate always' drop default router from routing table when it does have fully valid one received from another router in OSPF database".BTW, the outputs in the o...
I have found this document: http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t2/ipv6/ftipv6c.htmIt's pretty old (2003), so I am not sure whether it is valid. In it they write:QUOTE BEGINSIn IPv4, the Inverse Address Re...
Yes, I have checked the connectivity thoroughly (or so I hope):R5#sh ip ro 10.0.0.11Routing entry for 10.0.0.11/32 Known via "bgp 2", distance 200, metric 0 Tag 3, type internal Last update from 10.0.8.11 1d03h ago Routing Descriptor Blocks: * 1...