Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
Is there an SNMP trap for LTE signaling (RSSI, RSRP, RSRQ, SNR)? We would like to monitor the LTE signaling values and to trigger an alarm if they go below a threshold value.
Thanks.
Hello,
I'm trying to find information about PKI SNMP Traps for DMVPN spoke/hub routers using PKI. I found a document that touched on it but it was related to a Cisco router configured as a CA server. I need to know if there are SNMP PKI traps for spo...
Hello,I'm working with a Cisco 819 (C819HG-4G-V-K9) running IOS c800-universalk9-mz.SPA.153-3.M4.bin.We are trying to setup DMNR for a non-connected subnet. The idea is to create a Loopback interface (in this case Loopback300), assign it to a dummy v...
I would like to setup an MD5 passwords under the VTY, CON, and AUX line ports but the IOS (c2951-universalk9-mz.SPA.151-4.M1.bin) only let's me setup a "7" hidden password. Is there anyway to do this?
Hi,We have an old 3725 router with a HSSI card connected to a DL3100, which in turn is connected to a subrate DS3 circuit. The plan is to replace the router with a new 2951 router and a NM-T3/E3 card.After the router was replaced, I configured the NM...
Hi Nathan,Unfortunately, I haven't been able to find a solution. I even tried CiscoTAC and they couldn't help. Please let me know if you find better luck.Regards,Gus
Marvin,Thank you for your reply.We are also using TACACS+, will I still need to create a local username? I guess the point is to be able to access the device via out of band, so I would still need the local username. Is that an accurate assumption?Th...
Hi Paolo.Thanks for the quick response.I do not have access to the router at this time but I can tell you that the framinng is set to "c-bit", the dsu mode is set to "dsu mode 0", which is for a digilink mux and finally the dsu bandwidth is set to 1...
