Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Have two separate DCs, and need to connect them to extend L2 domains for VMotion.
The connection is DWDM and both sites will have two 3850s in Stack mode.
My question is which is the best approach to extend L2 across with this setup?
1. Th...
Hi!I am having a very ugly problem I have a 10MB Internet connection going through a 7206, then two ASAs in failover and then a Cisco CSS with a cluster of 3 web servers that receive constant HTTP transactions. The web servers hold a single web page...
Hi,I have configured the IPS Appliance and the IPS module on ASAs... now I need to configure an IDSM-2 on a 6500.Is it basically the same thing? I need to configure it as an IDS first, then we will change it to IPS, so I understand that I can use SPA...
Hi All,I need to establish an IPsec Lan-to-LAN tunnel between an ASA and a Cisco router.I also need to NAT both LANs on both sides when the traffic goes through the tunnel. I know how to do ''Policy NAT'' on the ASA, so that you can define with an AC...
Hi All,I have a simple question.Can I NAT in the ASA to an address that does not belong to the ASA itself? In other words...I have used NAT many times to translate the inside LANs to an address of the outside range of the ASA (but when the IP address...
Yes, I see you have defined a split tunneling policy. But that policy says to send all traffic through the tunnel (so is the same as not having a split tunneling policy).The question is: Do you want to send all IP traffic from the clients through the...
You need to determine what exactly do you want to accomplish with the VPN connection. I mean, do you want to send all IP traffic from the clients through the tunnel or would you like a split-tunnel policy to specify which traffic is going encrypted t...
Can somebody help me with this?Basically I need to know how to implement Policy NAT in the Router side to NAT the inside network to another range and know how to be able to establish the IPsec tunnel from either side.Thank you.Federico.
Hi,First of all, all IP traffic is going through the tunnel because you have a Split tunnel policy but it says to sendany traffic through the tunnel. (this means that when you connect with your VPN client, the machine will lose its localaccess to the...
