Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About Jorge Luis Covenas Chiroque
09-13-2019
Jorge Luis Covenas Chiroque
Beginner
Networking and Telecomm Specialist. CCNA, CCNA-V, CCNP, CCIP, CCDA and PMP. Experience in Technical Support, Service Delivery, Network Design and Project Management.
Recent Badges
Stats
Member since
11-08-2010
41
Posts
3
Helpful
1
Solution
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
in Wireless and Mobility
08-05-2019
11:53 AM
08-05-2019
11:53 AM
I had same issue but another situation: [Cisco Switch PoE 802.3af] ------ [PWRINJ6] ----[AP3802 Capwap mode] With interface at switch side with PoE enabled: brain: Power mode: Degraded/Reduced Power, power_detection: DC_adapter(FALSE), 802.3AF_POE(TRUE) So, we have to issue "power inline never" at switch 802.3af side to solve it: brain: Power mode: Full-Power, power_detection: DC_adapter(FALSE), 802.3AF_POE(FALSE) Regards. Jorge.
... View more
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
in Wireless and Mobility
07-31-2019
08:06 AM
07-31-2019
08:06 AM
Hi All. Thes issue is solved. I go to the other suggested Cisco IOS: 8.5.140.0 Upgrade from 8.2.170.0 to 8.5.140.0 was successfull. Thank a lot for your help. Jorge Note: upgrade from 8.2.170.0 to 8.3.x doesn´t work.
... View more
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
in Wireless and Mobility
07-31-2019
07:39 AM
07-31-2019
07:39 AM
HI Leo. Thanks for your time. Yes, I tested going from 8.2.150.0 to 8.2.170.0 successfully. But, new upgrade f rom 8.2.170.0 to 8.3.150.0 goes into "Failure while validating the signature!". After that, I tried upgrading from 8.2.170.0 to 8.3.143.0 with the same results. In the Controller´s traps I have this: "Fail to upgrade wlc, versión before upgrade: 8.2.170.0, versión after upgade: 8.2.170.0, fail reason: file check fail." I´ve checked MD5 checksum, and it is OK. Regards. Jorge
... View more
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
in Wireless and Mobility
07-31-2019
04:43 AM
07-31-2019
04:43 AM
Hi All. This is is to ask if you had this issue in order to help me with your experience. I was trying to upgrade CT2504 from 8.2.151.0 to 8.3.150.0 but when the copy is finished, either TFTP o SFTP, by CLI or GUI, fails and ends with this message: "Failure while validating the signature!". I´ve checked the files (MD5 checksum) and all are OK. FUS is 1.9. I tested going from 8.2.150.0 to 8.2.170.o successfully, but, again, from 8.2.170.0 I cannot go to 8.3.150.0. Plese help me with this issue. Regards
... View more
Labels:
Created by
Jorge Luis Covenas Chiroque
in Wireless - Mobility Documents
in Wireless - Mobility Documents
07-30-2019
11:20 AM
07-30-2019
11:20 AM
Great!
... View more
07-07-2017
08:29 AM
Hi All,
Try with this http://www.cisco.com/c/en/us/products/visio-stencil-listing.html
Regards.
Jorge
... View more
Created by
Jorge Luis Covenas Chiroque
in Switching
in Switching
07-06-2017
02:58 PM
07-06-2017
02:58 PM
HI, do you know if the 3560CX works with GLC-TE? In the compatiblity matrix it is not clear to me.
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/compatibility/matrix/GE_Tx_Matrix.html#_Toc487104941
Thanks in advance.
Jorge
... View more
05-03-2016
01:40 PM
Hi all,
Room temperature is about 17°C and we double check to airflow and clearance as specified in datasheet.
I have a TAC case and they suggested environment issues but we have other Nexus working well in same room but different rack. I thing there is a bug related because other Nexus running 6.2(12) has the same minor alarms for s31 in slot 9.
Any help would be very much appreciated.
Regards.
... View more
Created by
Jorge Luis Covenas Chiroque
in Other Data Center Subjects
in Other Data Center Subjects
04-21-2016
03:38 PM
04-21-2016
03:38 PM
Hi, I have the same issue with sensor 31. All the time we get messages from crossing minor alarm threshold. We already check for: cleaning air filter, check for non blocking of airflow and adequate cooling of room.
We are working with 6.2(12) and have a TAC case but they cannot find anything related to bug, just suggest to upgrade to 6.2(16) but it cannot be sure if this solve the issue.
Any ideas?
Jorge
... View more
02-04-2015
11:17 AM
I had the same issue with 3750stack with IOS 15.0(2)SE5. But the bug CSCsi78581 does not hit with this IOS. Do you know if there is another bug for 15.x?
... View more
01-29-2015
10:04 AM
Hi all, I have the same problem (ignored increasing in Gi 0/2), but working with NPE-G2 C7200-SPSERVICESK9-M 12.4(4)XD10. The bug say it is solved with 12.4(4)XD4.
... View more
Created by
Jorge Luis Covenas Chiroque
in Security Blogs
in Security Blogs
11-14-2014
12:11 PM
11-14-2014
12:11 PM
Hi Joshua. Dou you have this trainning recorder? If yes, please share it. Best Regards. Jorge
... View more
Created by
Jorge Luis Covenas Chiroque
in Archived Small Business Support
in Archived Small Business Support
11-13-2014
06:36 AM
11-13-2014
06:36 AM
Hi mtancil, Could you get a solution for message body filter? If yes, please share it. Thanks in advance. Jorge
... View more
Created by
Jorge Luis Covenas Chiroque
in Application Networking
in Application Networking
11-12-2014
08:51 AM
11-12-2014
08:51 AM
I has the same problem with read-only. I had to format flash: switch/Admin# backup all >> then I get a .tgz file and copy it to my PC switch/Admin# format flash: switch/Admin#restore all disk0:<backup filename>.tgz Then I could copy the new software image and all worked well.
... View more
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
in Wireless and Mobility
10-30-2014
10:56 AM
10-30-2014
10:56 AM
Hi Leo. I am going to upgrade from 6.0.199.4 to 7.4.121. But, 7.0.98.0 is not available for download. What intermediante version can I use? Thanks a lot in advance. Jorge
... View more
Latest Contributions by Jorge Luis Covenas Chiroque
- Latest Contributions by Jorge Luis Covenas Chiroque
- Discussions Jorge Luis Covenas Chiroque has Participated In
- TKBs Jorge Luis Covenas Chiroque has Participated In
- Blogs Jorge Luis Covenas Chiroque has Participated In
- Events Jorge Luis Covenas Chiroque has Participated In
- Videos Jorge Luis Covenas Chiroque has Participated In
08-05-2019
I had same issue but another situation: [Cisco Switch PoE 802.3af]
------ [PWRINJ6] ----[AP3802 Capw...
07-31-2019
Hi All. Thes issue is solved. I go to the other suggested Cisco IOS:
8.5.140.0Upgrade from 8.2.170.0...
07-31-2019
HI Leo.Thanks for your time.Yes, I tested going from 8.2.150.0 to
8.2.170.0 successfully.But, new up...
07-31-2019
Hi All. This is is to ask if you had this issue in order to help me with
your experience.I was tryin...
07-07-2017
Hi All, Try with this
http://www.cisco.com/c/en/us/products/visio-stencil-listing.html
Regards. Jorg...
07-06-2017
HI, do you know if the 3560CX works with GLC-TE? In the compatiblity
matrix it is not clear to me.
h...
05-03-2016
Hi all, Room temperature is about 17°C and we double check to airflow
and clearance as specified in ...
Created by
Jorge Luis Covenas Chiroque
in Other Data Center Subjects
04-21-2016
04-21-2016
Hi, I have the same issue with sensor 31. All the time we get messages
from crossing minor alarm thr...
02-04-2015
I had the same issue with 3750stack with IOS 15.0(2)SE5. But the bug
CSCsi78581 does not hit with th...
01-29-2015
Hi all, I have the same problem (ignored increasing in Gi 0/2), but
working with NPE-G2 C7200-SPSERV...
11-14-2014
Hi Joshua. Dou you have this trainning recorder?If yes, please share it.
Best Regards.Jorge
Created by
Jorge Luis Covenas Chiroque
in Archived Small Business Support
11-13-2014
11-13-2014
Hi mtancil,Could you get a solution for message body filter? If yes,
please share it.Thanks in advan...
Created by
Jorge Luis Covenas Chiroque
in Application Networking
11-12-2014
11-12-2014
I has the same problem with read-only. I had to format
flash:switch/Admin# backup all >> then I get ...
Created by
Jorge Luis Covenas Chiroque
in Wireless and Mobility
10-30-2014
10-30-2014
Hi Leo. I am going to upgrade from 6.0.199.4 to 7.4.121. But, 7.0.98.0
is not available for download...
Public Statistics
| Date Registered | 11-08-2010 09:49 PM |
| Date Last Visited | 09-13-2019 12:01 AM |
| Total Messages Posted | 41 |
| Total Helpful Votes Received | 3 |
Helpful Votes Given To
.jpg "Hall of Fame Master"){kind=icon}
