Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I have a Cisco ASA 5508, connected to a subnetted private network and two ISPs.The interfaces connected to both ISPs are DHCP, I can't know in advance what IP I will get when the lease get renewed.One such interface is configured as f...
Hello everybody,I recently acquired two CP-6851-3PCC used from a call center. The first thing I did was a factory reset. Unfortunately just after the factory reset both phones says "applying configuration" and soon after I can't enter the administrat...
Hello, I am using a UC540 as a small PBX.Connected to the system the extensions are a mix of FXS phones, VoIP phones and ISDN phones.I can call between extensions without issues and I can make or receive calls from SIP trunks. But somehow I can succe...
Hello, I am running a problem with the UC500 platform and I am hoping for some advice.I'm using a UC540W as a small pbx with a variety of internal extensions. The uc540 is connected on a private LAN with NAT access to the Internet, the NAT router als...
Thanks MHM, if I understood well with dhcp client route distance I can modify the metric of the DHCP leased gateway I will learn afterwards, so I can have two default routes with different metric. That is nice but it will only serve as a backup, one ...
Hi Nithin, I know the UC500 is EOL but that's what I have. As for using FLASH or Transfer key, well I use what's available on the IP phone, one has only the flash key the other only transfer, but that's not my problem, transferring calls with the ip ...
Hi Carlo,changing station-id name didn't work: I tried but it was no use. I kind of already figured the provider wanted the public number and not the extension's, that's why I created the translation-rule 10001 and translation-profile FW_OUTBOUND_CID...
