Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have been trying to setup AnyConnect IPSEC with IKEv2 without external RADIUS but without success.ISR4221 will be acting as GW for users as well IOS-CA (to enroll certs).Cert has been imported under personal cert on client.EKU is activated.Conf...
[UPDATE]
I was able to resolve this problem with SW L2 switches.
Thanks everyone for helping.
-------------------------------------------------------------------------------------
Hello everyone,
I'm struggling with scenario where I need split ...
[UPDATE 04/03/2018]
Problem has been resolved
Hi everyone,
I made script which pinging some IP's. The problem is with action end in conditional block because it causing problem with script triggering (getting error: "else" found without matching "i...
Hello everyone,
I'm walking through the case where I need check if UDLD is enabled on particular switch in the network.
The point is that I have mix environment (3560/3650/3750/3850) - so different OID for each switch.I'm using Microsoft SNMPwalk t...
Hi Rob, thanks for quick reply!Cert for PC was issued by internal IOS-CA and was exported as .pfx file.Regarding AnyConnect profile - I don't have AnyConnect profile but I used following template: ?xml version="1.0" encoding="UTF-8"?><AnyConnectProfi...
@Arne Bier - thanks for that valued information.
I have also one question regarding Authorization Policy - where this should be specify since I'm looking on my dashboard and have only policy sets, authorization profiles under policy tab, please take ...
@hslai - thank you for your post.
I already configured phone with username but it is unclear to me what kind of username that should be (I'm assumed that it can be artificial user but somewhere this artificial username should be authenticated is this...
