I have a number of Aironet 3502i WAP's and they all work fine. They get DHCP address from switch and allow clients, etc.All bar one allow console connection and show output on boot and command entry etc. so I need to find out why one of them would no...
Hello all, I have a DDNS account at no-ip and have one hostname updating correctly through my router usingip ddns update hostname etc. My issue is I cannot work out how to add a second host to use the same account. I may have found the solution at ht...
Hello all, Curious to know which is the best (subjective, I know) iOS version I should run on a 3650 WLC? sh run indicates I am running version 16.3 and I want to do some updates. Thank youCheers,
Hello all haven't been here for a long time but now need your assistance once again. My current config is working fine but I need to add a public addressable website which resides on my private lan address.I found "Configuring Network Address Transla...
I certainly hope I searched everywhere before I asked this question but if I didn't please point me at the URL.
I have a 3650 running Cisco IOS Software [Denali], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 16.3.3 and I have worke...
Thanks marce1000, can confirm there is no output even on cold boot so you have confirmed the console port as faulty. Very odd.I might convert this one to lightweight and use a different one for the autonomous to bypass the issue.Will accept your resp...
Thank you Sandeep, as I said to marce1000 the cable and console work on other WAP's. It is only this one.I did try speeds and flow but left everything "standard" and, thinking about it, I have actually tried it on a different computer too.
Thanks marce1000 but I can do that. Swap a different WAP in and no issue. It is only this single WAP which is causing the issue. I s'pose I can work around it but it is frustrating because if I want to make changes I need to plug it in inside (not in...
I finally got it working and thought I would post on here in case anyone else runs into the same issue. As it turns out my ISP blocks port 80 outbound so no matter what I did it was not going to work. The line I entered becameip nat inside source sta...
Thank you Paul but I couldn't get that to work. :( I'm sure I 'm just not doing something right as lots of people hosts lots of websites but I just can't get it to work. I don't know what other information I can give to try and get it working so do y...