Hello there,
I'm trying to track down the timer which triggers the event to send a BGP update to a peer when configuration has changed for example a route-map configured on a neighbor.
When doing a debug on a router running BGP it appears that once...
Hi there,
Has anybody had any luck getting ECDSA certificates to work with the anyconnect client on Cisco ASA's above 9.4.1?
This release of ASA now defaults to negotiate ECC ciphers which killed access to my anyconnect landing page as I was using ...
Hello,
In a practice lab I have two routers configured with OSPF directly connected.
I have established an OSPF adjacency and advertised a default route from each router with the "default-information originate always" command.
Each router will not...
Hello,When enabling storm control with action " SNMP Trap" does this restrict broadcast traffic and send an SNMP trap when the broadcast threshold is exceeded, or does it only send an SNMP trap and still allow broadcast traffic to pass?Cheers,
Gidday, Yes I understand why this check is good, I was just looking for documentation/reference to the protection. AD does not come into play with my test as each OSPF router did not actually have a static default. In summary, if OSPF router advert...
Gidday, I also encountered this problem. It seems that these switches have default mappings which you cannot change. You can only disable the behaviour. I have used the command "no qos rewrite ip dscp" to prevent the switch from doing it in the cos >...
Hi Mohammed,
Thanks for the response - I'm searching for a configuration guide online but everything points to using the CUCM.
Do you have or can point me to any documentation on the provisioning process without CUCM?
Cheers,