Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I'm using cisco LMS 4.0, I've discovered the device and next plan is to collect the device configuration.I would like to know, How I can collect the configuration for single device.What configuration changes required on my LMS & Cisco device....
Hi All,Is it possible for a given same user having one sort of privilege on some device, and other privilege on some other devices.If not Is there any alternative way to achieve it.Thanking You,Prashanth
Hi All,I've got Cisco ACS ( version 4.2 ), I've created group and permit command-show, Argument- configuration, privilege, vlanon my switch:aaa authorization config-commandsaaa authorization exec default group tacacs+ local aaa authorization commands...
Hi Expert,I dont know wether its right place to post this Issue, My problem is router enter into Rommon mode for every 2-3 minutes after its gets hard reboot ( Turning ON & Off ),Please find attached Doc of Router before entering into Rommon modeThan...
Thanks for revert,Scenario is like, I got 2 switches ( say A,B ) and 2 Users ( tom & jerry ).Tom should have full control on A&BJerry should have full control on A but restricted access on BHow can I achieve this?Thanking You,Prashanth
thank for revert,Its strange to see that sh run dont gives any output.Testing-Switch#sh runBuilding configuration...Current configuration : 13 bytes!!!!endTesting-Switch# sh configBuilding configuration...Current configuration : 2615 bytes!version 1...
Thank for revert Zhenning.1. So it means that inorder to make authorization to work, i need to define privilege command on switch & do ACS configuration.2. How do I know which command has got what privilege level? ( say show configuration - is level...
